Used to break loose supply nuts and trap fittings in tight cabinet spaces where a standard wrench will not fit. The basin wrench reaches the faucet mounting nuts behind the bowl.
Sink installation southlake TX done right the first time
When you need sink installation southlake TX homeowners can count on, we set the bowl, cut the counter, run new supply lines, and pressure-test every joint before we pack up.
Serving southlake and nearby areas.
How big is the sink job?
Full replacement
Undermount or new cut, new faucet, trap rebuild, shutoff check.
- 1. Simple swap Drop-in sink on an existing cut, same size, working shutoffs.
- 2. Full replacement Undermount or new cut, new faucet, trap rebuild, shutoff check.
- 3. Remodel scope Sink relocation, drain and supply extensions, counter modification.
Drag the needle to compareTouch and drag the needle
- 30Services from one local team
- 20Areas served around southlake
- Measure twiceTemplate and dry-fit before any cut
- Test every jointFill the bowl and watch for drips
What our sink installation covers
Every sink install includes the labor, sealant, supply lines, and haul-away.
Work order
Sink Installation- Old sink removal: We cut the caulk, release the clips, disconnect the supply and drain, and lift the old basin out. The old sink goes on our truck and leaves with us, so you are not stuck figuring out disposal.
- Counter fit and seal: We dry-fit the new bowl, verify the cut is square, and set it with sealant rated for your counter material. New mounting clips go in and get torqued evenly so the rim seats without cracking stone or quartz.
- New supply lines: Braided stainless supply lines go on both hot and cold, sized to your shutoffs. If the angle stops are frozen or weeping, we replace them so you have working shutoffs for the next repair.
- Drain and trap assembly: We rebuild the trap with the correct pitch, connect the tailpiece and disposal flange, and seal every threaded joint with Teflon tape or pipe thread sealant. Then we fill the bowl and watch for drips.
- Faucet and disposal hookup: If you are adding a new faucet or disposal, we install it in the same visit. That includes the sprayer, the dishwasher drain line, and the switch wiring for the disposal, all tested before we leave.
- Pressure test and cleanup: We run water through both taps, fill the bowl, run the disposal, and check every joint for two minutes. Then we vacuum the cabinet, wipe the counter, and walk you through the shutoffs.
What the first visit covers
First visit
We inspect the cabinet, check shutoffs and trap, confirm the sink type, and measure the counter opening before any work starts.
Sink installation at your home
Kitchen and bathroom sinks set, sealed, and tested in one visit.
Kitchen sink swap
Drop-in or undermount, new clips and sealant.
Bathroom vanity sink
New bowl, faucet, and trap in tight cabinets.
Farmhouse sink install
Apron-front fit with cabinet face adjustment.
Disposal and faucet
Installed and tested with the new sink.
Sink work for Southlake businesses
Break rooms, restrooms, and tenant spaces kept running with minimal downtime.
Office break rooms
Kitchen sinks and disposals for staff use.
Restaurant prep sinks
Health-code compliant drain and supply connections.
Retail restrooms
Vanity sinks replaced after hours or between shifts.
Sink installation southlake TX: what the job really involves
A sink set correctly the first time protects your counter, cabinet, and floor from water damage. We measure, seal, and test every joint before we leave, so the job holds up for years.
It sounds simple until you hit a corroded shutoff valve, a counter cut two inches off-center, or a drain line that no longer lines up with the new bowl. We handle all of it in one visit, from disconnecting the old fixture to testing the new one under full pressure.
Most calls we run in Southlake come from kitchens and bathrooms that are 15 to 25 years old. The original builder-grade faucet has failed, the undermount clips have rusted through, or a homeowner upgrading to quartz counters needs the sink reset with new brackets and sealant. If you have been searching sink installation near me southlake TX because water is pooling under the cabinet, we can usually get eyes on it the same day you call.
- What it is
- Removing an old sink and fitting a new one to the counter.
- When it helps
- Leaks, loose bowls, cracks, or a planned remodel.
- What you get
- A sealed, tested sink that drains correctly.
How a sink install runs, start to finish
Most sink replacements take two to four hours. Here is exactly what happens from the moment we pull into your driveway.
Tools and methods we use on sink jobs
Each method answers a different question. Together they leave very little to guess.
Cuts copper pipe and PEX tubing cleanly so new supply and drain lines fit without burrs. A square cut is what lets a compression or push fitting seal properly.
Used to sweat copper joints when we extend or repair supply lines during a sink relocation. We protect the cabinet and counter with heat shields before any flame comes out.
Clears clogs in the branch line and trap arm before the new sink goes in. A sink set over a partially blocked drain will back up within days, so we clear it first.
Blasts scale, grease, and root fragments out of drain lines when snaking is not enough. We use it on older Southlake homes where cast iron has built up years of buildup.
When Southlake homeowners call us
A kitchen remodel in Carillon needs the sink moved six inches to fit a new cabinet layout.
We cut the new counter opening, extend the drain and supply lines to the new location, and set the sink with new…
HomesA bathroom vanity in Timarron has a cracked drop-in sink and a faucet that drips constantly.
We pull the old sink, set a new drop-in bowl with fresh sealant, and install a new faucet with braided supply lines.
HomesA rental property near Southlake Town Square needs a durable sink that can handle tenant turnover.
We install a stainless drop-in sink with a ceramic-cartridge faucet and a new Insinkerator disposal.
BusinessesAn older home in Estes Park has a cast iron drain line that backs up every time the kitchen sink runs.
We camera the line, find the scale and root intrusion, and hydro jet the branch before installing the new sink.
Homes
How sink installation runs in Southlake
Southlake sits in Tarrant County, and most of the housing stock here was built between 1990 and 2015. That means we see a lot of builder-grade fixtures reaching the end of their life at the same time.
Timarron
Many homes here have original 1990s undermount sinks with rusted clips. We reset them with new brackets and sealant rated for the counter material.
Carillon
Newer builds with quartz counters and farmhouse sinks. We template carefully because a wrong cut on quartz cannot be patched.
Estes Park
Older homes with cast iron drain lines. We camera the branch before setting a new sink so backups do not return.
- Timarron
- Carillon
- Estes Park
- Southlake Town Square
- Clariden Ranch
From problem to finished result.
Slide to compare the photo with an illustrative inspection view. It is generated from the photo, not a measurement.
PhotoRusted undermount sink reset in Timarron
Before: A 1998 undermount kitchen sink had pulled away from the quartz counter, and the cabinet below showed water staining. The original clips had rusted through, and the sealant had failed along the back rim. The homeowner had been drying the cabinet with towels for two weeks.
After: We pulled the sink, cleaned the counter edge, and reset it with new stainless clips and silicone rated for quartz. The trap was rebuilt, and two corroded shutoffs were replaced. The cabinet stayed dry through a full pressure test, and the sink sat flush with no gap.
Bathroom vanity upgrade in Carillon
Before: A guest bathroom had a cracked drop-in sink with a dripping faucet that had stained the bowl. The shutoffs under the vanity were frozen, and the trap was corroded. The homeowner wanted a quick update before family visited.
After: We installed a new drop-in sink and faucet, replaced both shutoffs, and rebuilt the trap with new fittings. The drip was gone, the cabinet was dry, and the whole job finished in about three hours. The homeowner added a matching faucet in the hall bath the next month.
Kitchen sink relocation during remodel in Estes Park
Before: A kitchen remodel moved the sink six inches to fit a new cabinet layout. The old drain line did not line up, and the supply lines were too short. The homeowner had a contractor ready to close up the cabinets but no plumbing plan.
After: We cut the new counter opening, extended the drain with PVC pipe and the supplies with PEX tubing, and set the sink with new clips. The trap arm was re-pitched to code, and a new Insinkerator disposal was installed. The inspection passed on the first visit.
Sink problems we fix every week
Most sink calls start with one of these four issues.
Water pooling in the cabinet under the sink
Moisture rots the cabinet floor, warps the door, and can seep into the subfloor.
Sink rocks or pulls away from the counter
A loose undermount sink can drop entirely, taking the disposal and drain with it.
Slow drain or standing water in the bowl
A clogged branch line backs up into the sink, and if it is downstream of the trap, it can also flood the dishwasher or disposal.
Faucet drips or will not shut off completely
A dripping faucet wastes hundreds of gallons a year and stains the bowl.
Why homeowners book us for sink work
A sink that leaks, rocks, or drains slow costs you more every month in water damage and wasted time.
No leaks, no callbacks
We pressure-test every supply line and fill the bowl to check the drain seal before we leave.
Correct cut, correct fit
Undermount sink installation southlake jobs live or die on the counter cut.
Drainage that actually works
A new sink on a clogged or improperly pitched drain line will back up within a week.
Fixtures matched to your water
Southlake water runs hard, and cheap faucets scale up fast.
What you receive on the job
Clear records you can keep and share.
Written findings
Notes on shutoffs, trap, and drain condition.
Install photos
Before and after shots of the sink and connections.
Fixture record
Make and model of the sink and faucet installed.
16 years of sink work in Tarrant County
Southlake Oakline Plumbing has been installing and replacing sinks since 2010.
Shutoff condition
We open and close each valve to confirm it seals and will not weep under pressure.
Trap arm pitch
We check slope with a level so the drain carries water without pooling in the trap.
Counter edge
We inspect the cut edge for soft spots or delamination before setting the new bowl.
Is your Southlake neighborhood covered?
Type your ZIP code or town to check. If you are nearby and not listed, call and ask.
southlake ZIP codes
- 76092
Towns we serve.
Based in southlake and covering the places around it. Pick one for local details.
What Southlake homeowners say
Our undermount kitchen sink had been sagging for months and the cabinet below was getting soft. The tech templated a new cut, set new clips, and resealed everything in about three hours. He also replaced two corroded shutoffs I did not know were failing. No leaks, no mess, and he took the old sink with him. Exactly what I wanted from a sink replacement in Southlake.
I called about a bathroom sink install and expected to wait a week. They had a tech out the next afternoon. He swapped the faucet, rebuilt the trap, and found the drain line was partially clogged from hair and soap scum. Snaked it, tested everything, and the sink drains better than it ever did. Fair price and no upsell.
We upgraded to a farmhouse sink during a kitchen remodel and needed the counter cut adjusted. The crew measured twice, checked the drain alignment, and installed a new Insinkerator disposal while they were in there. They pressure-tested every joint and showed me the shutoffs before leaving. Clean work and zero callbacks.
Sink installation questions we hear every week
Short answers for the first few minutes. The team can cover the rest.
Still have a question?
Describe what you are seeing and we will point you to the right next step.
(682) 470-5111The cost to install sink southlake projects stays in that range unless you are moving drain lines, which we quote separately before starting.
You can, but the two failure points are the counter cut and the drain seal. A drop-in swap on an existing cut is a reasonable DIY job if you have a basin wrench and patience. If you are unsure which you have, call us and we will tell you straight.
A standard drop-in replacement takes about two hours. Undermount installs with new clips and sealant run three to four hours. If we find corroded shutoffs, a cracked trap, or a drain line that needs snaking, add an hour. We schedule a half-day window so there is no rush and no second trip.
We handle both, and we pull permits when the job calls for it.
Other work we handle while we are there
Other services from the same team.
- Garbage Disposal RepairA humming disposal that will not drain usually means a jam or a failed motor.
- Garbage Disposal InstallationNew disposal installation includes removing the old unit, checking the drain connections, and mounting the new disposal.
- Water Softener InstallationHard water leaves scale in pipes and shortens water heater life.
Book your sink installation southlake TX visit today
(682) 470-5111We quote the job upfront, finish most installs in one visit, and haul the old sink away. Call Southlake Oakline Plumbing at (682) 470-5111.
contact Southlake Oakline Plumbing
Call us at (682) 470-5111 for same-day service or to schedule an appointment. You can also email [email protected] or stop by our office in Southlake.