Acoustic microphones and thermal imaging cameras that read temperature differences as small as 2 degrees. We use these to pinpoint hidden leaks behind walls and under slabs without demolition.
Leak repair southlake TX that stops the water for good
When water shows up where it shouldn't, leak repair southlake TX homeowners trust starts with finding the source, not guessing at it. We handle slab leaks, burst pipes, dripping supply lines, and hidden wall leaks across Tarrant County.
Serving southlake and nearby areas.
How big is the leak job?
Hidden leak
Behind a wall or under a floor. Detection first, then repair.
- 1. Fixture leak Faucet, toilet, or supply line under a sink. Usually one visit.
- 2. Hidden leak Behind a wall or under a floor. Detection first, then repair.
- 3. Slab or main line Under concrete or in the main line. Planned in writing first.
Drag the needle to compareTouch and drag the needle
- 30Services from one local team
- 20Areas served around southlake
- Camera firstWe look before we open anything
- Pressure testWe confirm the fix holds
What our leak repair service includes
Every leak repair job includes the basics: full system inspection, leak detection, the repair itself, and a pressure test to confirm the fix. What varies is access and materials.
Work order
Leak Repair- Full pressure test: We pressurize your system to 80 psi and hold it for 15 minutes. If the gauge drops, we know there is a leak and roughly how big it is. You get a photo of the final reading after the repair.
- Leak detection and marking: Acoustic listening equipment and thermal imaging narrow the leak to a 6-inch area. We mark it with tape and show you the spot before we open anything. No guesswork, no unnecessary demolition.
- Repair with code-correct materials: We use copper pipe for hot water lines, PEX tubing where flexibility matters, and PVC pipe for drains. All fittings meet Uniform Plumbing Code standards. We carry SharkBite, brass fittings, and solder on every truck.
- Cleanup and debris removal: We bag all debris, wipe down surfaces, and haul everything off. If we opened drywall, we leave it clean and ready for patching. You do not have to clean up after us.
- Written repair summary: You get a written summary of what failed, what we replaced, and the parts used. If you are selling your home, this document shows the buyer the work was done correctly and to code.
What the first visit covers
First visit
We inspect the system, pressure-test the lines, and mark the leak location. You see the spot before we open anything.
Leak repair for Southlake homes
From dripping faucets to slab leaks, we handle it all.
Slab leaks
Under-concrete pipe repair or reroute
Wall leaks
Hidden supply line repair behind drywall
Faucet and toilet
Cartridge, flapper, and valve replacement
Burst pipes
Freeze damage repair and insulation
Leak repair for Southlake businesses
We work around your hours to keep water off the floor and your doors open.
Retail spaces
Supply line and restroom leak repair
Restaurants
Drain and supply line leaks fixed fast
Office buildings
Hidden leak detection and repair
What leak repair southlake TX actually involves
A leak never gets smaller on its own. Water finds the weakest point and keeps going until you stop it. Fixing the pipe is the cheap part. Fixing the damage is not.
Leak repair southlake TX is the process of locating water escaping from your plumbing system and sealing or replacing the failed section so it stops. That can mean anything from tightening a compression fitting under a sink to cutting out a corroded copper pipe and soldering in a new section. We pressurize the line, watch the gauge, and use acoustic listening gear to hear water moving behind walls or under a slab. Once we know exactly where it is, we open the smallest access point possible and make the repair.
Slab leaks are common in older Tarrant County homes where copper pipe sits in direct contact with soil. We also see plenty of faucet leak repair southlake Texas jobs where a worn cartridge or failed O-ring has been dripping into a cabinet for months.
- What it is
- Finding and sealing water escaping from your pipes
- When it helps
- High water bill, wet spots, running sounds
- What you get
- A pressure-tested repair and written summary
How our leak repair process works
You know what is happening and what it costs before we start.
Tools and methods we use for leak repair
Each method answers a different question. Together they leave very little to guess.
A flexible camera that goes into drain and sewer lines. We use it to check for root intrusion, cracks, and scale that could be causing or hiding a leak.
Standard hand tools for cutting out failed pipe sections and tightening fittings. Every truck carries multiple sizes.
For copper pipe repairs, we solder joints the traditional way or use a press tool for faster, flame-free connections. Both methods meet code.
High-pressure water jet that clears scale, grease, and roots from drain lines. We use it when a leak is caused by a blocked or damaged drain.
When Southlake homeowners call us for leak repair
You wake up to water pooling around the water heater in your garage.
We diagnose the source: T&P valve, inlet fitting, or cracked tank.
HomesYour water bill doubled and you can hear water running when everything is off.
We shut off the main, pressure-test the system, and use acoustic listening equipment to find the leak.
HomesA pipe froze and burst during a winter freeze in your attic or crawlspace.
We shut off the main, drain the lines, and cut out the burst section.
HomesYou are selling your home and the buyer's inspector flagged a leak under the slab.
We confirm the leak, document it with photos and pressure test readings, and repair or reroute the line.
Homes
How leak repair works in Southlake specifically
Southlake sits on clay soil that expands and contracts with moisture. That movement puts stress on buried pipes and is a big reason slab leaks are common here.
Timarron
Many homes here were built in the 1990s with copper pipe now reaching the end of its service life.
Carillon
Newer construction with PEX tubing. Leaks here are usually at fittings or where the line connects to a fixture. We carry the right PEX repair couplings on every truck.
Southlake Town Square
Condos and mixed-use buildings with shared walls. Hidden leaks can travel between units, so we use thermal imaging and acoustic equipment to find the exact source before opening anything.
- Timarron
- Carillon
- Southlake Town Square
- Clariden Ranch
- Estes Park
From problem to finished result.
Slide to compare the photo with an illustrative inspection view. It is generated from the photo, not a measurement.
PhotoSlab leak rerouted in Timarron
Before: The copper hot water line under the slab had failed and was leaking into the soil. We confirmed with acoustic equipment and a meter test.
After: We rerouted the hot water line through the attic using PEX tubing, bypassing the slab entirely. The pressure test held at 80 psi for 30 minutes. Water bill dropped back to normal the next month.
Hidden wall leak fixed in Carillon
Before: A ceiling stain in the kitchen kept coming back after painting. The homeowner had called a handyman twice with no fix. We traced the leak with thermal imaging to a failed supply line behind the master shower wall, 20 feet from the stain.
After: We opened a 12-inch section of wall, replaced the corroded copper pipe with new copper and brass fittings, and pressure-tested to 80 psi. The stain stopped growing and the wall was patched clean.
Burst pipe repaired after freeze in Estes Park
Before: A hard freeze burst a copper pipe in the attic. Water was running down through the ceiling into a bedroom. The homeowner shut off the main and called us at 6 a.m. We were on-site by 7:15 a.m.
After: We cut out the burst section, installed new copper pipe with soldered joints, and pressure-tested to 80 psi. The line held. We also insulated the pipe to reduce the risk of another freeze.
Leak problems we solve for Southlake homeowners
Most leaks we see fall into a handful of categories.
Water bill jumped but no visible leak
A hidden leak can waste 10,000 gallons a month and rot framing, subfloor, and drywall before you see a drop.
Warm spot on the floor or sound of running water
That is a classic slab leak. Hot water line under the concrete has failed.
Ceiling stain that keeps coming back
Water travels along joists and pipes. A stain in your kitchen might come from a shower leak 20 feet away. Painting over it does nothing.
Dripping faucet or running toilet
A dripping faucet wastes 3,000 gallons a year. A running toilet wastes 200 gallons a day.
Why Southlake homeowners call us for leaks
A small leak wastes 10,000 gallons a year or more and rots framing, warps floors, and feeds mold.
Stop the water fast
We carry SharkBite fittings, copper couplings, and PEX repair sections on every truck, so most supply-line leaks get fixed on the first visit.
Find hidden leaks without demolition
Our leak detection equipment includes acoustic microphones and thermal imaging that read temperature differences as small as 2 degrees.
Protect your foundation
A slab leak repair southlake Texas job handled early prevents soil movement under your foundation.
Lower your water bill
A single dripping faucet wastes about 3,000 gallons per year. A running toilet can waste 200 gallons a day.
What you receive on a leak repair job
Clear records you can keep and share.
Pressure test photo
Gauge reading before and after the repair
Repair summary
What failed, what we replaced, parts used
Leak location mark
Tape mark showing where the leak was found
16 years of leak repair experience in Southlake
Southlake Oakline Plumbing has been fixing leaks in Tarrant County since 2010. We work to Uniform Plumbing Code and International Plumbing Code standards on every job.
Pressure gauge
We pressurize to 80 psi and watch for 15 minutes. A drop means there is a leak.
Water meter
With all fixtures off, we watch the dial. Movement means water is escaping somewhere.
Thermal camera
We read temperature differences as small as 2 degrees to find hidden leaks behind walls.
Is your Southlake neighborhood covered?
Type your ZIP code or town to check. If you are nearby and not listed, call and ask.
southlake ZIP codes
- 76092
Towns we serve.
Based in southlake and covering the places around it. Pick one for local details.
What Southlake customers say
We had a slab leak that showed up as a warm spot in the hallway. Southlake Oakline found it in about 40 minutes with their listening equipment and rerouted the line through the attic. No more breaking concrete. They cleaned up everything and showed me the pressure test before they left.
A pipe in the wall behind our master shower started leaking and stained the ceiling below. They opened a small section, replaced the copper pipe, and had it patched and tested in one afternoon. The price was exactly what they quoted. I have already recommended them to two neighbors in Carillon.
We manage a retail strip and had a water leak in a tenant space that was driving up the water bill. Southlake Oakline traced it to a failed supply line behind a wall, fixed it, and had us back to normal in under four hours. They work clean and they communicate. We use them for all our plumbing now.
Frequently asked questions about leak repair in Southlake
Short answers for the first few minutes. The team can cover the rest.
Still have a question?
Describe what you are seeing and we will point you to the right next step.
(682) 470-5111A faucet cartridge swap is on the low end. We give you a flat price before we start, so you know the number going in.
We locate the leak with acoustic equipment and thermal imaging, then open a small section of the slab. From there we either repair the copper pipe in place or reroute the line through the attic or walls to bypass the slab entirely. Rerouting is often the better long-term fix because it removes the pipe from soil contact. Most slab repairs take one to three days.
You can tighten a compression fitting or replace a faucet cartridge. Plus, a wrong repair can flood your home and cost far more than the original fix.
A visible supply-line leak takes one to two hours. A hidden wall leak takes three to five hours because we have to find it first. A slab leak repair southlake Texas job runs one to three days if we reroute the line. We give you a time window when we schedule and call if anything changes.
Other plumbing services we offer in Southlake
Other services from the same team.
Need leak repair southlake TX today?
(682) 470-5111Same-day service on most calls. Flat pricing before we start. Call now and we will walk you through shutting off the main while a tech heads your way.
contact Southlake Oakline Plumbing
Call us at (682) 470-5111 for same-day service or to schedule an appointment. You can also email [email protected] or stop by our office in Southlake.